![]() Now the block was ready to assemble into the rocket stove configuration.Ĭlick Photo To Begin AnimationThe animated photo shows the sequence of assembly from the bottom to the top. I then flipped the block over and repeated the process until the wall was completely removed. ![]() Rather than just smacking the wall mid-way I began to chip the upper edges, alternating sides and bit by bit reduced the concrete down toward the block center. ![]() The concrete was resistant to chiseling so I decided to just use the hammer and chip it away in the same fashion as I would do for flint knapping. I tried to create a break-line along the inner edge. When I returned home I got a hammer and cold chisel and set about chipping away the outer end of one of the blocks. The total cost of the material was $7.03. I went to a local hardware superstore and was surprised that they did not have the mid-hole block that I sought so I decided to buy four blocks and I would remove the outer end of one of the blocks in order to make it work. This project called for three standard two-hole blocks and one mid-hole block with the single hole in the middle with open holes on each end. One particular configuration used only four blocks that made it a very simple and inexpensive project so I decided to assemble one for myself. There have been a number of rocket stoves featured on various social media websites including different configurations using concrete blocks.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |